Investigating the effect of pressure on a vertical two-phase upward flow with a high viscosity liquid

Abstract

This article presents void fraction and pressure gradient data for sulfur hexafluoride (SF6) with gas densities of 28 and 45 kg/m3 and oil (with viscosity 35 times that for water) in a 127 mm diameter pipe. The superficial velocities of gas ranged from 0.1 to 3 m/s and those for liquid from 0.1 to 1 m/s, respectively. Measurements of void fraction data were recorded using a capacitance wire mesh sensor (WMS) system, which permits the 3D visualization of the flow patterns. All the data were obtained with a data acquisition frequency of 1,000 Hz. A differential pressure transducer was used to measure the pressure drops along the length of the pipe. The WMS provide time and cross-sectionally resolved data on void fraction and from an analysis of its output, flow patterns were identified using the characteristic signatures of probability density function (PDF) plot of time series of void fraction. The PDF plots showed the single peak shapes associated with bubbly and churn flows but not the twin-peaked shape usually seen in slug flows. This confirms previous work in larger diameter pipes but with less viscous liquids. For the bubble and churn flows investigated, the pressure gradient was observed to decrease with an increase in gas superficial velocity. Nevertheless, there was an insignificant observed effect of pressure on void fraction below certain transitional flow rates, the effect however became significant beyond these values. In the present work, wisps appear to be smaller, which might be due to the different fluid properties of the working fluids employed. In addition, wisps are easily revealed as long as there is a transition between churn and annular flows regardless of the pressure. Experimental data on void fraction and pressure gradient are compared against existing data. Reasonably good agreements were observed from the results of the comparison.